Home  >  Products  >  Proximity Card Reader  >  EM Proximity Card Reader  >   Anti-Vandal RFID reader JAR117E

Anti-Vandal RFID reader JAR117E

Products Information

Description
 
   125Khz RFID + PIN code reader JAR117E, it is a metal cased, anit-vandal reader, The ideal for high traffic and extremely harsh envionments.
     Reader with built-in 125KHz RFID proximtiy card reader module, reads EM4100 or compatible RFID proximty card. And with standard 3*4 keypad and alos one bell key.
    ESD protection on Wiegand output terminal, Suger protection on DC power input terminal. 

Model Name: JAR117E

Wiring
Red: Power 5-16V
Black: Power ground
Green: Wiegand output D0
White: Wiegand output D1
Brown: Green LED control
Blue: Buzzer control
Yellow: Hold

Specification

 

Dimension 120mm  x58mm x20 mm 
Power requirement 5-16VDC at 100mA, A linear regulator is recommended
Support card EM4100 proximity cards and fobtags.
Interface Weigand
Read range upto 6cm
Frequency 122-128KHz
Operating temperature -30°C to +60°C
Operating humidity 5%-95% (non-condensing)
Audio/Visual Indication Green & Red and Buzzer signal output
Response Time Less than 0.2 seconds
Cable length 500mm
Weight 500gram

 


LED/Buzzer function description

 

LED function: The LED color is normally in RED. It starts with 2 green flashes and will keep in RED. When HID cards close to the reader, LED will  flash green momentarily, this indicates cards were read properly. When LED control signal is actived by access controller host, LED will changes to green.
Beeper Function: When Power up the reader, Beeper will ring 2 times. When put HID cards close to the reader, a short beep will be emitted. This indicates that HID card was read properly. 
Buzzer control line      
When this control line is actived to lower by access controller host or connect to Ground line, buzzer will kepp ringing untill the line is released. 
Green LED control line      
When it is actived by access controller host or connect to ground line, Green LED will keep lighting untill the line is released.
Hold function: when this line is actived by accessc ontroller host or connect to ground,the reader will stop reading cards untill be released.

 

Key Value output

 

when each key is press, 4 digital BCD code will be sent via wiegnad interface as key value. they are:
                key "0" =0000 ;  key"1"=0001; key "2" =0010 ;  key"3"=0011; key "4" =0100 ;  key"5"=0101;                                                                                     
                key "6" =0110 ;  key"7"=0111; key "8" =1000 ;  key"9"=1001; key "*" =1010 ;  key"#"=1011;
BELL key:
 when BELL key is pressed, it will short the output terminal BL1 and BL2, that can be connected with a door bell.

 



  • Email :
replyto
chat online

Taylor (Jacky.zhang.skype)
Toni (JATSALES6)
Anny (JATSALES5)

taylor@szjat.com.cn
Toni@szjat.com.cn
anny@szjat.com.cn